Initially, it was clear that none of the LEDs can not be compared with the glow of neon (fluorescent) tube, but on the other hand the high cost, fragility, complexity of installation forced to give up the neon. I had to find another option. Get more background information with materials from Ebay. Appointment of illumination on the underside of the car tuning-Eastham need not be explained. The glow gives a sharp view of your car and the speed is not affected. Initially, it was clear that none of the LEDs can not be compared with the glow neon (fluorescent) tube, but on the other hand the high cost, fragility, complexity of installation forced to give up the neon. Had to find another option. Had the idea to arrange the LEDs is perpendicular to the surface sex in small casings as enshrined in the rapids and under the bumpers. Material costs were low, all it took I bought in a store building materials, led nakovyryal of Chinese lighters, some had buy at radio.

For the manufacture of light you need the following materials: – plastic, thin-walled pipe diameter 40-50mm. – Plexiglas (complex) – LEDs (super bright) – Resistor (500 ohms.) – Glue "Moment" – a transparent silicone – Thin twin conductor copper wire, there is a necessary tool in every garage, proceed to manufacture. Beforehand, I did not know that from this venture will turn out, but started taking pictures immediately. The first step was to make the case, for preliminary estimates of their must have been 12 pieces (3 to front, 3 on the rear bumper and 3 for each threshold) from the pipe cut into small pieces, a cylindrical shape, resembling a sleeve length 60-70mm.